Hoshizaki IM-21CPE Bedienungsanleitung Seite 9

ENGLISH
4. LOCATION
This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 1°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
[IM-21/30CPE/CWPE, IM-45CPE]
Side View
Front
* No clearance required on sides
Top View
Left
15cm
Top View
Left
15cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.
Top
15cm
Rear
15cm
ICEMAKER
[IM-45/65/100/130PE/WPE, IM-130CPE]
Rear
15cm
Right
15cm
ICEMAKER
Front
[IM-240DPE/DWPE, IM-240XPE/XWPE]
Rear
30cm
Right
50cm
ICEMAKER
Front
WARNING
CAUTION
NOTICE
IMPORTANT
[IM-240PE/WPE/APE/AWPE]
Side View
Front
ICEMAKER
* 5cm clearance required on sides
Side View
Front
ICEMAKER
Side View
Top
Front
ICEMAKER
6
Top
30cm
Rear
30cm
Top
15cm
Rear
15cm
30cm
Rear
30cm