Troubleshooting - Quick MILL 0835 Bedienungsanleitung

11. TROUBLESHOOTING

Fault
Machine does not work (go on)
Little or no coffee dispensed
Too much coffee is dispensed
Coffee leaks from the dispensing unit
Cold coffee
Noisy pump
24
Fault type
Electrical
Electrical
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Electrical
Hydraulic
Hydraulic
Hydraulic
Hydraulic
MOD. 0835 - 02835 - 03035
Solution
Plug in the machine.
Check the fuses.
Fill the water tank.
Descale the machine.
Replace the lime filter
Clean filters.
Put the steam wand inside.
Reduce the amount of coffee in the filter holder.
Too fine grind.
Increase the amount of coffee in the filter holder.
Too coarse grind.
Decrease the coffee quantity device.
Put the filter holder in its seat correctly.
Clean the edge of the filter holder.
Filter holder seal worn and needs to be replaced.
Reduce the amount of coffee in the filter holder.
Wait for the light to go out.
Put the filter holder in to warm it up.
Fill the water tank.
Replace the lime filter
Check the suction pipe to see if it is clogged.