Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7) Upgrading your system
The SQ-IO Korg Analog Sequencer can easily be used
along with the MS-IO for some interesting
Here are just two examples.
(Refer
to the SQ-IO
manual
for more
details.)
(I)
One simple idea is to set the SQ-IO to produce a different
pitch and tone color in the MS-10 at each step. Then use the
internal clock Of the SQ-IO to run through
the steps. This results in
automatic
control
of the
MS-10.
10
O CV O
VC
O CHANNEL
EXT IN
O CHANNEL
EXT TRIG IN
MS.tO
(2) For performing
live, another effective
way of using the SQ-IO
is to set up a patch so that the SQ-IO advances one Step and changes
the tone color every time you play a key on the MS-10.
IN O
O CHANNE
O
O EXT S TEP CONTRO
TRIG
OUT
nn
MS-JO
Two MS-IO synthesizers can be used together to increase the
richness and depth of the sound.
our
cv our
out
MS-to
Connect
patch cords
the MS-IO
on the left to the VCO CV IN and TRIG
on the right. With this arrangement,
results.
together when you play the keyboard of the one on the left. But if
you try to play the right hand keyboard,
owner's
because it has been disconnected
IN and TRIG
going to use before you set up the patch.
Using separate amps (or left and right stereo channels) for each
synthesizer
You can also try setting all the controls
both synthesizers and then varying the pitch slightly
so. 10
A
them. This can produce a phase effect or jet effect. This can be
a
effectively used both on the stageand in the recording studio for
MULTIPLE TRIG OUT
multi•track
There are many ways of using other equipment
But the simplest way of upgrading your system is to use a lot of
patch cords. It's also the cheapest. So stock up with plenty of Korg
Patch Cords. The teachings of Doctor
what we want and how to go about getting it before plugging patch
cords into every hole we see. But if you run out of jacks you can
always
buy or make a junction
so•10
L
A
L
TO AMP
CV IN
[RIG JN
MS-iO
from
the KBD
CV OUT
and TRIG
IN of the MS-IO
both synthesizers
operate
nothing
will happen
by the patch cords in the VCO CV
IN input jacks. So decide which keyboard you are
gives a better effect.
at the same positions
on one of
recording.
with the MS•IO.
Korg remind us to consider
box.
ORD
8) Caution
OIJT of
(I) On the MS-IO front panel are five small rubber plugs which
cover internal adjustment
control
settings. They have been adjusted at the factory
optimum
results. Changing their setting will result in performance
deterioration,
and possible harm to the instrument.
(2) Pay attention to the voltage indications (ON+5V, —5Væ+5V,
5Vpp, etc.) on the patch panel and their relationship with the block
diagram and signal flow chart. The patch panel itself is arranged in a
for
flow chart to make things simpler.
Note that if you connect a —5V&+5V
input, nothing
will happen during the
signal. It will only operate from
the output and the input and whether the signal is analog or
digital,
the latter indicated
Which
input
should
it be connected
to?
trimmer
controls.
Do not change these
to give
control
signal to a 0—+5V
portion
of the control
SO always consider both
by
GND.
O
O
OUT
7
Werbung
