S+S REGELTECHNIK HYGRASGARD RFTF-wModbus Bedienungs- Und Montageanleitung Seite 20

G U
HYGRASGARD
BUS ADDRESS
The bus address is set to "1" at the factory and can be changed using DIP switches.
The bus address can be changed at any time, even after pairing to a gateway.
With display units, the modified bus address is shown on the display for approx. 30 seconds.
Configuration using "193" as an example
Bus adress
(binary coded, value selectable from 1 to 247)
DIP 1 DIP 2 DIP 3
O N O N OFF
128 64 32
The device address in the range of 1 to 247 is set at DIP switch [A].
For switch positions 1 to 8 see the table on the back!
Address 0 is reserved for broadcast messages. Addresses greater than 247 must not be assigned
and are ignored by the device. The DIP switches are binary-coded with the following values:
DIP 1 = 128 ............ DIP 1 = ON
DIP 2 = 64 ............ DIP 2 = ON
DIP 3 = 32 ............ DIP 3 = OFF
DIP 4 = 16 ............ DIP 4 = OFF
DIP 5 = 8 ............ DIP 5 = OFF
DIP 6 = 4 ............ DIP 6 = OFF
DIP 7 = 2 ............ DIP 7 = OFF
1 ............ DIP 8 = ON
DIP 8 =
BUS PARAMETERS
The bus parameters for W-Modbus sensors are automatically configured.
The required settings (e.g. baud rate) are made directly on the W-Modbus gateway.
DIAGNOSTICS
Integrated fault diagnostics function (see "Function 08 Diagnostics" table)
APP MODE
The Lumenradio W-Modbus app can access W-Modbus units.
To do this, Bluetooth must be activated manually on the unit (using the "Pair" push-button).
The unit then becomes visible and can be connected via the app.
For further information, see "Commissioning" ("Pair" push-button)
In App mode, the Lumenradio W-Modbus app can access the gateway:
- Firmware updates of the wireless module
- Error detection (duplicate bus addresses, communication errors, etc.)
- Individual unit names
- Checking the network setup
- Documentation of the network setup (PDF)
You can find more information via the help function in the app.
The app is available for Android and Apple mobile devices through the app store.
Link for Apple Lumenradio W-Modbus app:
https://apps.apple.com/de/app/w-modbus/id6472275984
Link for Android Lumenradio W-Modbus app:
https://play.google.com/store/apps/details?id=com.lumenradio.wmodbus
® xx - wModbus | Configuration
DIP 4 DIP 5 DIP 6
OFF OFF OFF
16 8 4
The switch positions shown here result in the Modbus address 128 + 64 + 1 = 193
DIP switch [ A ]
ON
DIP 7 DIP 8
▸
OFF O N
1 2 3 4 5 6 7 8
2 1
20
DIP A