Cleaning The Unit; Delivery Set - Rondell Rde-1307 Betriebsanweisung

bowl (14) and smoothly, without distortions, lower the
attachment into the bowl, while the slots on the attach-
ment (12) should match the corresponding protrusions
inside the bowl (14).
•
Take the knife (11) by the drive gear and place it in the
center hole of the attachment (12).
Attention! Be careful, the knife blades are very sharp!
Note: Check whether the attachment (12) is set properly,
otherwise the geared lid (10) will not close.
•
Install the geared lid (10) on the chopper bowl (14).
•
Align the « » symbol on the lid (10) with the mark on
the handle of the bowl (14) and place the lid on the bowl
then turn the lid (10) clockwise until it clicks, while the
mark on the handle of the bowl (14) and the «
bol on the lid (10) should match.
If you have difficulty fitting the lid (10), turn the knife (11)
slightly by the drive gear so that the teeth on the knife
match the drive in the lid (10).
•
Place the motor block (4) on the geared lid (10) and
press it lightly until the locks (5) click.
•
Insert the power plug into the mains socket.
•
Set the required speed with the control knob (1).
•
To switch the unit on, press and hold down the but-
ton (2).
•
When the button (3) is pressed, the knife (11) rotates at
maximum rotation speed.
•
Place the products into the feeding chute of the geared
lid (10); use the pusher (19) for food feeding.
•
Press the pusher gently while feeding products.
•
After you finish using the unit, take the power plug
out of the socket, press the locks (5), and remove the
motor unit (4) from the lid (10).
•
Then remove the geared lid (10) from the bowl (14) by
pressing the button (15) and turning the lid (10) coun-
terclockwise.
•
Remove the remaining products in the grid (13) using
the pusher (20).
•
Carefully remove the knife (11) and the attachment (12).
•
Take the chopped products out of the chopper bowl
(14).
•
Clean, wash and dry all the used parts immediately
after operation.

CLEANING THE UNIT

Important! Be careful when cleaning the knife blades
(11, 16), disc (17) and and cubic attachment grid (13).
Attention! The blades are very sharp!
•
Always switch the unit off and unplug it after operation
or before cleaning.
•
Clean, wash and dry all the used parts immediately
after operation. It is recommended to wash all remov-
able parts in warm water with neutral detergent. You
can wash the discs in the dishwasher.
•
For easy cleaning of the grid (13), remove it from the
attachment (12), see pic. 6, and remove the remaining
products in the grid (13) using the pusher (20).
•
After processing of salty or sour products rinse the
used attachments with water immediately.
•
Clean the motor unit (4) with a damp cloth.
•
» sym- Do not use coarse sponges, abrasives and solvents to
clean the unit.
•
Do not immerse the motor unit (4), the whisk gear (7),
the mashed potato attachment (9), the geared lid (10) in
water or any other liquids, or put them in the dishwasher.
•
For easy cleaning of the mashed potato attachments
(9) it is provided with removable spatulas.
•
Hold the attachment (9) with one hand and turn the
removable spatulas clockwise with the other hand and
remove the attachment. Wash the removable spatulas,
rinse the grate of the attachment (9), preventing the
washing solution from getting into the built-in gear of the
attachment. Dry and assemble the potato mash making
attachment. Hold the attachment (9) with one hand, and
with the other hand, place the spatulas on the drive axle
and turn them counterclockwise until they stop.
•
While possessing products with strong dyeing prop-
erties (for instance carrot or beetroot) the bowls or
attachments can get colored, wipe the attachments or
bowls with a cloth, dampened in vegetable oil.
STORAGE
•
Clean and dry the attachments thoroughly before tak-
ing them away for storage.
•
Do not wind the power cord around the motor unit.
•
Keep the blender set away from children in a dry cool
place.

DELIVERY SET

Motor unit – 1 pc.
Blender attachment – 1 pc.
Whisk reducer – 1 pc.
Whisk attachment – 1 pc.
17
ENGLISH