Function Test With Test Magnet - ACS Vibrocont SHM-300 Bedienungsanleitung

7.3 7.3

Function test with test magnet

Function test with test magnet
WARNING WARNING
L L
Risk of injury! Risk of injury!
‣ ‣
Ensure that no dangerous processes are activated in the system. Ensure that no dangerous processes are activated in the system.
To perform a function test, hold the test magnet against the marking on the nameplate (for at To perform a function test, hold the test magnet against the marking on the nameplate (for at
least 2 seconds). This inverts the current switching status and the yellow LED changes state. least 2 seconds). This inverts the current switching status and the yellow LED changes state.
When the magnet is removed, the switching status valid at that time is adopted. When the magnet is removed, the switching status valid at that time is adopted.
 22  22 Test magnet and marking Test magnet and marking
The test magnet is not included in the delivery and can be ordered as an optional The test magnet is not included in the delivery and can be ordered as an optional
accessory. →  65 accessory. →  65
Endress+Hauser Endress+Hauser
ACS-CONTROL-SYSTEM GmbH l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l info@acs-controlsystem.de
A0020960 A0020960
63 63
63