5.1.6
Marking
The marking indicates the position of the tuning fork. If installed horizontally in vessels, the
marking is face up.
The marking appears either as a material specification (e.g. 316L) or a thread designation
(e.g. G ½") in the following locations:
• On the hexagonal bolt of the process adapter
• On the nameplate
• On the weld-in adapter
18
Orientation in the vessel
19
Orientation in the pipe
Endress+Hauser
ACS-CONTROL-SYSTEM GmbH l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l info@acs-controlsystem.de
A0022641
A0022804
49
49