Cleanmaxx VC9391 Gebrauchsanleitung Seite 22

EN
3. Turn the plug of the dirty water
container (B) clockwise and remove.
B
4. Pour away the dirty water and rinse out
the dirty water container thoroughly
with warm water.
5. Remove the fresh water container (2)
from the container support (14) (see the
"Preparing the Device / Filling the Fresh
Water Container" section) and pour
away the rest of the cleaning solution.
Rinse out the fresh water container
thoroughly with warm water.
6. Allow all parts to dry completely before
assembling them.
7. Insert the fresh water container back
into the device (see the "Before Initial
Use" chapter).
8. Tighten the plug counterclockwise onto
the dirt container and insert the dirty
water container into the main unit.
When you do this, make sure that the
recess on the dirty water container fits
in the frame of the main unit. Press
the dirty water container against the
frame of the main unit until you hear it
engage.
Cleaning the Carpet Suction Nozzle
1. After cleaning a carpet, clean the carpet
suction nozzle (6). To do this, flip up the
closure cap of the hose connection (7).
Grip hold of the upper end of the carpet
suction nozzle, pull it up and remove.
22
07948_DE-EN-FR-NL_A5_V2.indb 22 07948_DE-EN-FR-NL_A5_V2.indb 22
2. Rinse out the carpet suction nozzle
thoroughly with warm water.
3. Allow the carpet suction nozzle to dry
completely and insert it back into the
main unit. To do this, place the locking
lugs of the carpet suction nozzle into
the recesses on the main unit and press
down the carpet suction nozzle. It must
engage audibly.
Cleaning the Carpet Brush
1. For cleaning the carpet brush (5) place
the device on the floor so that the
bottom of the device is accessible.
Attention! Make sure you empty the
water containers prior to cleaning.
2. Press together the locking device (C, D)
and pull out the carpet brush.
3. Rinse out the carpet brush (6) thoroughly
under warm, running water.
4. Allow the carpet brush to dry completely
and insert it back into the main unit.
Make sure it is in the correct position
(see picture). Press together the locking
device and press it into the recess on the
bottom of the main unit. It must engage
audibly.
C
D
12.02.2024 16:19:45 12.02.2024 16:19:45