Cleanmaxx VC9391 Gebrauchsanleitung Seite 21

Carpet Cleaner
stubborn patches of dirt, go over a strip
several times if necessary.
9. When the dirty water container (8) is
filled to the Max marking, it must be
emptied (see the "After Use" chapter,
"Cleaning the Water Containers" section).
10. When the dirty water container is to be
emptied, the fresh water container (2) is
to be topped up or the cleaning is to be
finished, place the device on the towel
or cloth provided. Switch off the device
by stepping on the On / Off switch, and
move the handle to a vertical position.
11. Remove the mains plug from the plug
socket.
Cleaning Upholstered Furniture
1. Use the upholstery nozzle for cleaning
upholstered furniture. To do this, first flip
up the closure cap of the hose connec­
tion (7), place the end of the hose onto
the connection and press this down
firmly. You must feel it engage.
2. Step on the On / Off switch (12) to
switch on the device.
3. Pull the upholstery nozzle along the
edge of the upholstered furniture and
hold down the button for dispensing
the cleaning solution on the handle of
the upholstery nozzle (A). Let go of the
button (A) at the other end of the strip.
4. Pull the upholstery nozzle over the same
strip. The dirty water will be sucked up.
07948_DE-EN-FR-NL_A5_V2.indb 21 07948_DE-EN-FR-NL_A5_V2.indb 21
A
5. Continue in the same way as with
carpet cleaning (see the "Use" chapter,
" Cleaning the Carpet" section).
AFTER USE
• Empty both water containers after each
use.
• Allow the freshly cleaned surfaces to dry
completely.
• If possible, do not tread on the carpet
while it is still damp. If it has to be trod­
den on, put down white or colourfast
towels and tread on them.
• If cleaning solution has got onto wooden
floors or furniture, wipe it away.
• Vacuum the dry carpet or upholstered
furniture with a vacuum cleaner. If pos­
sible, use a brush attachment to do this.
Cleaning the Device
Please Note!
■
Remove the mains plug from the plug
socket before cleaning the article.
■
Do not use any chemical cleaning agents
to clean the device. These may damage
the device.
■
Before the device can be stored away,
the water containers must be emptied
and rinsed out.
Cleaning the Water Containers
1. Make sure that the mains plug has been
pulled out.
2. Empty the dirty water container (8). To
do this, press down the handle of the
dirty water container (3) and pull the
dirty water container forwards out of
the main unit.
EN
21
12.02.2024 16:19:45 12.02.2024 16:19:45