Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Appliance; Cleaning The Equipment - Siemens KI28F Serie Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Cleaning the appliance

Attention!
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
Never clean shelves and containers in the
dishwasher. The parts may warp!
Proceed as follows:
S Before cleaning: Switch off the
appliance.
S Pull out the mains plug or switch off the
fuse.
S Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing up liquid. The rinsing water
must not run into the light.
S Wipe the door seal with clear water only
and then wipe dry thoroughly.
S Rinsing water must not run through the
drainage hole into the evaporation area.
S After cleaning reconnect and switch on
the appliance.
Note
Regularly clean condensation channels
and drainage hole, Fig. 0, with cotton
buds, etc. so that the condensation can
run out.
After cleaning the appliance, re insert the
stopper into the drainage hole for
functional reasons.

Cleaning the equipment

To clean the equipment, all variable parts
of the refrigerator compartment can be
taken out (see chapter Variable interior
design").
Taking out the drawers
Fig. q
Tilt drawers forwards and take out.
To insert drawer, place the front of the
drawer on the telescopic rails and push
into the appliance. The drawer is engaged
by pushing it into the appliance.
Taking out the humidity filter
Fig. 1/18
The humidity filter above the humidity
drawer can be removed for cleaning.
To do this, first take out the humidity
drawer and pull out the humidity filter.
Lift off the filter cover, Fig. w, and take out
the filter. Clean in lukewarm water. Leave
to dry and re assemble.
Remove telescopic rails
Fig. r
1. Pull out the telescopic rails.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear pin.
4. Push telescopic rail together, push
backwards above the rear pin and
disengage.
Install telescopic rails
1. Place the extended telescopic rail on
the front pin.
2. Pull the telescopic rail forwards slightly
until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.
en
35

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ki25f serieKi40f serie

Inhaltsverzeichnis