Hitachi DAT-88EX Bedienungsanleitung Seite 5

@8) Program number indicator
*
Displays the number of the tune being recorded
(played back)
during recording (playback).
@) Repeat indicator
@8)Program indicator
@ Level indicator
+ Adjust the recording level so the
segments
G0 Digital input indicator
@i) After recording indicator
@2 Pause indicator
@3Play indicator
@4Record indicator
@5)Eject indicator
@)Tape remaining indicator
This
displays the tape
remaining
time
in 8 steps.
Since it uses a percentage display, the time taken to
change is different depending on the length of tape
used. The
one-step time is as follows for different
tapes.
Notes:
* There may be a difference depending on the tape.
* The tape remaining indicator lights for about 15
seconds after recording or playback starts.
* The tape remaining indicator does not light during
fast forward and rewind.
6) Subcodes indicator
6) Tape counter/Time/Program time indicators
@9Power socket
@ Digital input/output jacks
@ Remote control sensor jack
@ Operate switch
@After recording switch
@ Analog/Digital input select switch
@nfrared signal transmitter
@Numeric buttons
Press these buttons for easy program selection.
@Cue button
Press this button during play to search the required
position of tape while fast forwarding. Release the
button to return to normal play.
@Review button
Press this button during play to search the required
position of tape while rewinding. Release the button
to return to normal play.
BEFORE USING
Note:
Remove
the cassette
when not
using this unit or
moving
it from a cold place to a warm
place.
mBattery level alarm
Temperature rise alarm
When the DAT-88EX is used or left at high tempera-
tures in a place exposed to direct sunlight, in a car
with its doors closed or near a heating appliance, the
DAT-88EX stops operation and the whole display
panel flashes. In this case, remove the cassette, turn
the power off and leave for about an hour in a well-
ventilated place before reusing the DAT-88EX.
It is recommended that you use the DAT-88EX at a
temperature of 5°C~35°C.
Note:
If the whole display panel flashes and the cassette
cannot be used, it can be considered that an anomaly
has occurred in the power block. If the DAT-88EX is
left in this state, the power block may be damaged.
Turn the power off and contact the dealer from whom
you purchased the DAT-88EX.
Englis