Hitachi DAT-88EX Bedienungsanleitung Seite 12

To renumber program ——
number of tunes
When a tape is edited, program numbers of tunes
become out of order. Use this function to arrange the
order of program numbers.
1. Set the After recording switch @ to "ON".
2. Press the ID Mode button @) to set the subcode
record mode to "RENUMBER". ("RENUMBER" will
light in the Subcodes indicator 67.)
3. Press the Write button @ in the stop or play mode.
(The Play indicator 8 will flash and "WRITE" will
flash in the Subcodes indicator @).)
The tape is rewound to its start automatically, start
IDs are searched and the program numbers are re-
numbered starting from 1.
— To renumber from a specified —
program number
(partial renumbering)
Use the partial renumbering function after you have
added start IDs from a certain tune.
a
In the above case, designate "19" and perform partial
renumbering.
1. Set the After recording switch @ to "ON".
2. Press the ID Mode button @) to set the subcodes
record mode to "RENUMBER". ("RENUMBER" will
light in the Subcodes indicator @7).)
3. Press the Program number select buttons (UP 4/
DOWN ¥) ©) in the stop or play mode to designate
the program number. (The designated program
number will flash in the Program number indicator
@).)
4. Press the Write button @). (The Play indicator @3
will flash and "WRITE" will flash in the Subcodes in-
dicator 62.)
The program numbers are renumbered starting from
the designated program number.
12
——— To record skip IDs
Record a skip ID if there is a section you want to skip
during playback. You can skip the section from where
the skip ID was recorded, to the next start ID.
Skip ID Next start ID
Skip
1. Set the After recording switch @3 to "ON".
2. Press the ID Mode button @) to set the subcode
record mode to "SK-ID". ("SK-ID" will light in the
Subcodes indicator @)).)
3. Press the Write button @) during playback. ("WRITE
will light in the Subcodes indicator @)).)
A skip ID is recorded where the button is pressed.
Notes:
* When the After recording switch @3 is left "ON",
skipping is not performed even when a skip ID is
detected during playback.
* A skip ID cannot be recorded when start. IDs are
being recorded.
¢« A skip ID cannot be recorded in a non-recorded
section.
To erase skip IDs
1. Set the After recording switch @ to "ON".
2. Press the ID Mode button @) to set the subcode
record mode to "SK-ID". ("SK-ID" will light in the
Subcodes indicator 67.)
3. Press the Erase button (1) in the stop or play mode.
(The Play indicator 63 will flash and "ERASE" will
flash in the Subcodes indicator 62.)
The DAT-88EX returns to the skip ID one step before
and erases it.
Skip ID Skip ID
LE: TE alae
7 ERASE
Erases