Refco REFMATE Kurzanleitung Seite 3

Intended use
The manifold has been developed for measuring and regulating the
pressure and temperature conditions in mobile and stationary
refrigeration systems and heat pumps as well. Only trained refrigera-
tion technicians are permitted to use this REFCO product.
Important safety instructions
Read all safety instructions thoroughly and comply with them.
The symbol Warning! indicates a possible dangerous situation that
can lead to serious injury if not avoided.
Safety instructions
The manifold may not be used for other purposes outside the
air-conditioning and refrigeration sector.
The manifold must not be used for pressures higher than 60 bar /
870 psi / 6000 kPa / 6 MPa.
Under no circumstances should the manifold be used as a pres-
sure reducing valve, especially when nitrogen N2 is used.
The manifold must not be used with the refrigerant ammonia
(NH3 / R717) and not in EX zones.
The manifold must not be exposed to rain or used in damp or wet
environments.
Always wear protective goggles and gloves when working with
the manifold.
REFCO products have been specially designed and manufactu-
red for use by trained refrigeration technicians. Due to the high
pressures and chemical and physical gases used in refrigeration
systems, REFCO disclaims all responsibility and liability for
accidents, injuries and death.
REFCO expressly points out that the products should only be used
by professionally trained specialists.