Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.8 Power management
The power management divides the
power between two cooking zones in a
pair (see the illustration). The Power
function increases the power to the max-
imum level for one cooking zone in the
pair and decreases the power in the sec-
ond cooking zone. The display for the
reduced zone changes between two lev-
els.
5.9 Timer
Use it to set an automatic switch-off time
for a cooking zone.
1.
Set the cooking zone. Touch
again and again until the indicator
for the necessary cooking zone
comes on.
You must set the cooking zone
before you activate the timer.
2.
Set the heat setting for the cooking
zone. You can also set it after you
activate the timer.
3.
To activate the timer or change the
set time, touch + or - on the hob
control panel. The maximum time
you can set is 99 minutes.
The indicator of the cooking zone
flashes slowly. The timer starts to
count down.
4.
To see the remaining time, touch
again and again until the indicator
for the necessary cooking zone flash-
es quickly. The display shows the re-
maining time.
When the set time ends, 00 flashes
and an acoustic signal sounds. The
cooking zone deactivates.
5.
Touch
to stop the signal.
To deactivate the timer before
the set time is completed, set the
cooking zone with
-. The remaining time counts
down to 00. The indicator of the
cooking zone goes out.
You can use the timer as a Minute Mind-
er when the cooking zones do not oper-
ate. To do this, set the cooking zone and
activate the timer but do not set the
heat setting.
5.10 Stop and Go
The Stop and Go
cooking zones that operate to the lowest
heat setting (
).
This function does not deactivate the
timer function.
• To activate this function, touch
The display shows the symbol
• To deactivate this function, touch
The display shows the heat setting
that you set before.
When the Stop and Go function
operates, you cannot change the
heat settings.
5.11 Lock
When the cooking zones operate, you
can lock the control panel but not
prevents an accidental change of the
heat setting.
This function does not deactivate the
timer function.
1.
Set the heat setting.
2.
To activate this function, touch
The display shows the symbol
4 seconds.
3.
To deactivate this function, touch
. The display shows the heat setting
that you set before.
When you deactivate the appli-
ance, the function is deactivated.
When you activate the appliance, the
display shows SAFE .
The lock function locks or un-
locks the oven interface at the
same time.
ENGLISH
11
and touch
function sets all
.
.
.
. It
.
for
Werbung
