Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Additionally this button is also used for channel 4, where you
can use different modes such as: discharge, refresh and test.
Simply short press the button and select the desired process.
CURRENT – default charging current for channels C1 – C4 is
500mA and 120mA for 9V battery. Short press this button to
select different charging or discharging current in discharge
mode (discharge works only for slot C4).
7. Basic operations.
Immediately after inserting batteries the charger will carry
the diagnostic procedure to determine the battery type and its
condition. The charger will try to reactivate zero voltage cells by
applying limited charging current for about 60 s. If no voltage
increase is observed, the charger will indicate an error – all
symbols will flash and ERROR message will appear - „Err".
Depending on the battery voltage it will automatically detect
Ni-MH and Li-ion batteries. When Li-ion cell is detected it is
possible to manually activate the Li-FePO4 or Li-HV charging
mode as described in point 6. Battery type symbol is indicated
on LCD display (Ni-MH, Li-ion, LiFePO4, Li-ion 4.35V).
When inserting next batteries into the charger, the LCD will
always show the status of the last inserted cell. The user can
manually review other battery compartments by pressing SLOT
button.
If no further action is taken by the user, the charger will start
the charge process with default settings – with 500mA current
for slots C1-C4 and 120mA for 9V slots 1-2.
9
Werbung
