Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12. Test mode.*
In this mode the charger will charge the battery first, then
discharge and charge again. The current mechanism is the
same as in the refresh mode – the discharge current is
connected to the charge current. For 500mA max charge current
the discharge current will be set to 200mA, every higher current
will cause to set the discharge current to 400mA. When the
entire process is completed the full battery will occur next to
corresponding slot - C4. Finished process is also indicated by
'End' label on LCD. For a new, good quality cell the discharged
capacity should be very close to the rated capacity of the
cell.
*NOTICE: DISCHARGE, REFRESH and TEST modes are
available only for C4 slot!
13. Product disposal.
The crossed-out wheeled-bin symbol on your
product, battery, literature or packaging, reminds you
that all electrical and electronic products, batteries
and accumulators must be taken to separate
collection at the end of their working life. This
requirement applies in the European Union. Do not
dispose any of these products as unsorted municipal
waste. By proper disposal you contribute to the protection of the
environment and natural resources. More on:
www.everActive.pl/eco.
13
Werbung
