Werbung
Introduction
This manual contains installation operation and maintenance instructions. Please read the manual completely before using.
Safety Instructions
Please read the entire instruction manual before operating the Vortex Mixer.
WARNING! DO NOT use the Vortex Mixer in a hazardous atmosphere or with hazardous materials for which the unit was not
designed. Also, the user should be aware that the protection provided by the equipment may be impaired if used with
accessories not provided or recommended by the manufacturer or used in a manner not specified by the manufacturer.
Always operate unit on a level surface for best performance and maximum safety.
DO NOT lift the Vortex Mixer by the head. All heads, including cup head, are removable. They can pop off if lifted by them.
CAUTION! To avoid electrical shock, completely cut off power to the unit by disconnecting the power cord from the wall outlet.
Disconnect unit from the power supply prior to maintenance and servicing.
Spills should be removed promptly. DO NOT immerse the unit for cleaning.
DO NOT operate the unit if it shows signs of electrical or mechanical damage.
Earth Ground - Protective Conductor Terminal
Alternating Current
Package Contents
Fixed Speed, Analog, Digital or Pulsing Vortex Mixer
Description
183cm power cord with Euro plug and UK plug or Swiss adapter
cup head*
7,6cm head*
7,6cm rubber head cover*
* These accessories come with all units except the Pulsing Vortex Mixer which is also supplied with a 1,5 to 2mL Micro-Tube Holder with built-in
cup head.
Installation
Upon receiving the VWR Vortex Mixer, check to ensure that no damage has occurred during shipment. It is important that any damage that
occurred in transport is detected at the time of unpacking. If you do find such damage the carrier must be notified immediately.
After unpacking, place the Vortex Mixer on a level bench or table, away from explosive vapors. Ensure that the surface on which the unit is
placed will withstand typical heat produced by the unit. Always place the unit on a sturdy work surface.
The Vortex Mixer is supplied with a power cord that should be plugged into a properly grounded outlet. If the supplied power cord does not
meet your needs, please use an approved power cord that suits local codes and electric supply. Replacement of the plug must be made by a
qualified electrician.
4
vwr.com I Instruction manual VWR
®
Fixed Speed Analogue Digital & Pulsing Vortex Mixers
Quantity
1
1
1
1
EN
Werbung
