Genmitsu 4040 Reno CNC Installationsanleitung Seite 30

Test Project
2. Run G-code for processing
Step I: Click [open], select the G-code to run
Step 2: Click on the manual operation
workpiece just touch
Step 3: Click [ZeroXY] [Zero Z] Clear the XYZ axis coordinate.
Step 4: Click [Send] running G-code.
3. About firmware
The parameters of the control board have been configured according to 4040 Reno
28
panel, move the spindle to the starting.
parameters
Help
saanns=.a rt
GI ZS r5M
GI
rrw
noo
Point of the engraving, so that the tool and the
3
2