Genmitsu 4040 Reno CNC Installationsanleitung Seite 12

Mechanical
2. Place the profile on the front side of the machine as shown in the figure. Then use the (2) unscrewed rounded hex screws through
the profile to connect the Y-axis module. Keep the screws loose for now
3. Push the profile to stick to the front of the Y-axis modules, then use (4) M5 x 25mm rounded hex screws through the front baffle
to connect the profile. Keep the screws loose for now
10
Installation
M5 x 25
Rounded Hex
Screw
Just Unscrewed Small Cup Head Screw
Stick