Genmitsu 4040 Reno CNC Installationsanleitung Seite 18

Mechanical Installation
2. Adjust the Z-axis slider to a position that does not interfere with screw mounting by unscrewing the Z-axis motor handwheel
Install the Z-axis slider on the bracket with the (4) M5x14 rounded hex screws.
(4) M5x14 Rounded Hex Screw
Note: In order to meet different engraving requirements, the Z-axis can be installed at different heights. The steps are the same as
step4. The figure below shows the installation effect of different heights.
16