Genmitsu 4040 Reno CNC Installationsanleitung Seite 14

Mechanical
2. Place the profile on the rear side of the machine as shown in the figure Then use the (2) rounded hex head screws through the
profile to connect the Y-axis module. Pre-installed screws, please do not lock.
3. Push the profile to stick to the rear of the Y-axis modules, then use (4) M5 x 25mm rounded hex screws through the rear baffle to
connect the profile. Keep the screws loose for now
Stick
12
Installation
M5 x 25
Rounded Hex
Screw