Parkside PSSFS 3 A2 Bedienungs- Und Sicherheitshinweise Seite 16

Issue
The display needle
jumps to the highest value
of the display scale
The display needle
always jumping to highest
value of the display
scale . The display
1 ] [
needle cannot be aligned
with the middle part of the
display scale .
14 GB
Potential cause
The receiver signal is too
[ 6 ]
high for the product .
.
1 ] [
The connected LNB is
is
[ 6 ]
a high capacity type
with high amplification
(> 60 dB) . / The
connected satellite antenna
is larger than 1 metre .
Solution
Reduce the sensitivity
of the product: Turn the
control knob counter-
3 ] [
clockwise until the display
needle is aligned with
6 ] [
the middle part of the
display scale .
1 ] [
Insert an attenuation
controller (0–20 dB)
between the LNB and the
product .