Silvercrest 451609 2310 Bedienungsanleitung Seite 12

Inserting/removing the scale filter insert
1) Remove the lid 1 .
2) Reach into the jug with one hand and hold it in front of the scale filter insert 7 .
3) From the outside, press with your other hand through the spout 6 against the
scale filter insert 7 and catch this with the other hand that is in the jug .
4) Clean the scale filter insert 7 with a slightly moistened dishcloth under
running water .
5) After cleaning, replace the scale filter insert 7 by pressing it into the spout 6
from the inside with the 3 catches to the front .
NOTE
► If scale deposits have solidified in the scale filter insert 7, place the filter in
a water-vinegar solution with a ratio of 6:1 for a few hours . The scale deposits
will dissolve . Rinse the scale filter insert 7 with plenty of fresh water .
Storage
■ Allow the appliance to cool down completely before putting it into storage .
■ Wind the power cable around the cable winder 5 under the base 4 .
■ Store the appliance at a dry location .
Troubleshooting
Problem
The appliance
does not
function .
The ON/OFF
switch 3 does
not engage .
SWKC 3000 E3
Cause
The plug is not inserted into a
mains power socket .
The appliance is not switched on . Switch the appliance on .
The appliance is defective .
The appliance is overheated
and the overheating protection
is active .
The kettle is not on the base 4 . Place the kettle on the base 4 .
The appliance is defective .
Remedy
Insert the plug into a mains
power socket .
In this case, contact
Customer Services .
Allow the appliance to cool
down .
In this case, contact
Customer Services .
GB │ IE │ NI │ CY │ 9 ■