Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General
Device concept
Scope of supply
Conventional:
Not shown:
-
Configuration
-
options
-
-
this document
Depending on the routing of the wire electrode before the wire straightener, the wire
straightener is used to increase or reduce the wire electrode's degree of bend.
Depending on how the wire straightener is installed (contact roller above or below),
the wire electrode's degree of bend is either increased or decreased.
Depending on the requirement - contact roller above or below - the positions of the
wire run-off plate and the inlet nozzle can be interchanged.
The wire straightener is used for bending
or straightening wire electrodes. The wire
straightener can accommodate wire elec-
trode diameters of 0.8 mm (0.03 in.) to 1.6
mm (0.06 in.).
Two versions of the wire straightener are
available: one for conventional welding
systems and one for robot welding sys-
tems.
Robot:
42,0001,4376
Not shown:
-
this document
42,0001,4375
9
Werbung
