Einfache Bedienung - Yaesu ft-450d Bedienungsanleitung

E O
ASY PERATION
[ POWER ( ON/OFF )] switch
PHONES
KEY
R
ECEIVING
1. Connect your antenna to the ANT jack on the rear
panel.
2. Connect the after-market DC power supply (or car
battery) using the supplied DC power cable, and set
the POWER switch of the DC power supply to on.
3. Press and hold in the [ POWER ( ON/OFF )] switch
for one second to turn the transceiver on.
4. Rotate the [ SQL/RF GAIN ] knob to the fully
counter-clockwise position.
5. Rotate the [ AF GAIN ] knob to set a comfortable
audio level on incoming signals or noise. Clock-
wise rotation of the [ AF GAIN ] knob increases
the volume level.
6. Press the [ BAND ] / [ BAND ] button to select the
amateur band which you wish to begin operating.
7. Press the [ MODE ] / [ MODE ] button to select
the desired operating mode.
8. Rotate the [ MAIN DIAL ] knob to set the desired
frequency.
Page 14
[ BAND ] / [ BAND ] button
[ MAIN DIAL ] knob
[ MODE ] / [ MODE ] button
T
RANSMIT
1. Connect the supplied MH-31
on the front panel.
2. To transmit, press the microphone's PTT (Push
To Talk) switch, speak into the microphone in a
normal voice level.
3. Release the PTT switch to return to the receive
mode.
The [ DSP/SEL ] knob is used for operating
various functions depending on the situation.
If you can not change the frequency/memory
channel by tuning the [ DSP/SEL ] knob, the
[ DSP/SEL ] knob is selected to operate of one
of the DSP functions.
In this case, press the [ DSP ] button several
times until the ">" icon disappears from the
DSP Graphic Display.
[ AF GAIN ] knob
[ SQL/RF GAIN ] knob
A8J
N
OTICE
Regarding of the [ DSP/SEL ] knob
FT-450D O
PERATION
to the MIC jack
M
ANUAL