Werbung
▪
Tighten the set screws.
7.4
Mounting the parallel fence (Fig. 4)
▪
The parallel fence allows sawing parallel to an edge at a maximum distance of 10 cm.
▪
Loosen the lock know of edge guide.
▪
Slide the edge guide through the slots in the shoe to the desired width.
▪
Tighten the lock bolt to secure it in the position.
▪
Ensure that the edge guide rests against the wood along its entire length to give a
consistent parallel cuts.
8 OPERATION
8.1
Instructions for use
▪
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
▪
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
▪
Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
▪
For straight cuts along a drawn line use the marking for straight cuts.
▪
For bevel cuts along a drawn line use the marking for bevel cuts.
8.2
Switching on and off (Fig. 5)
▪
To switch on the circular saw, press the lock-off button (13) and pull the on/off switch
trigger (12).
▪
To switch the tool off, release the on/off switch.
8.3
Dust extraction
A vacuum cleaner can be connected to the dust extraction connector, either directly to the
connector or using an adapter.
▪
If necessary, connect an adapter to the connector (1).
▪
Preferably use a vacuum cleaner for industrial use.
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2
Lubrication
From time to time, apply a drop of oil to the thread of the lock screw.
Copyright © 2022 VARO
POWC2030
P a g e
| 6
EN
www.varo.com
Werbung
