Using The Remote Controller; For Best Results - Panasonic CZ-RWSU2N Bedienungsanleitung

9. Using the Remote Controller

• Point the transmitter of the remote controller at the receiver. When the
signal is received properly, it will beep one time. (It only beeps two times
when the unit starts operating.)
• The signal can be received at a distance of up to about 6 meters. This
distance should be used only as a guide. It depends on battery strength.
• Make sure nothing is between the remote controller and the receiver that
could block the signal.
• Do not leave the remote controller in direct sunlight, where the wind from
the air conditioner can blow directly on it, or near any other heat source.
• Take care not to drop, throw, or wash the remote controller with water.
• The signal from the remote controller may not be received in rooms with
rapid start fl uorescent lighting, inverter lights, plasma displays, LCD
televisions (monitor), etc. For more information, please contact the
distributor where the product was purchased.
Wall Mount Use
• Press
you wish to mount the remote
controller and make sure the
signal is received properly.
• Pull the remote controller
forward to remove it.

10. For Best Results

Don't get the remote controller too far away from the receiver.
This may cause a malfunction.
Be sure to keep the remote controller in the same room as the receiver.
Point the remote controller at the receiver.
When the signal is received properly, it will beep one time.
Avoid locating the remote controller where it is covered, such as
behind a curtain.
Keep it out in the open.
18
(EN)
from the location
Fasten the remote
control holder with
screws.
Remote control
holder
Fitting the remote
controller in the
holder
2
Push
1
Fit in