Panasonic CZ-RWSU2N Bedienungsanleitung Seite 9

2. Names and Operations (Cont.)
Receiver
1. Receiver
Receives the signal sent from the
remote controller.
2. Emergency operation button
Indicator lamps
When an error occurs, one of the lamps
fl ashes. When an indicator lamp is
fl ashing, refer to "14. Before Requesting
Service".
3. OPERATION lamp
Lights up when the unit is
operating.
4. TIMER lamp
Lights up when the timer is set.
5. STANDBY lamp
• The lamp in the HEAT mode
lights up at the following times:
during the startup, during the
thermostat operation, and during
the defrosting.
• The lamp fl ashes when an error
occurs.
6. FILTER lamp
This lamp is for notifying you
when the fi lter needs to be
cleaned.
7. Address switch
See "11. Addresses".
Note
• If non-cooling/heating free type is
being used, it will beep twice and the
operating lamp will light up on the
display; if the timer and standby lamps
blink alternately, a confl ict between the
heating and cooling exists, so the unit
cannot operate in the desired mode.
(On models that do not have an Auto
function, even if Auto is selected, it
works in the same way.)
• When the local operation is disabled
by centralized control or similar cause,
and if the Start/Stop
Temperature setting button
is pressed, the unit will beep fi ve times
and the change will not be made.
, Mode or
(EN)
9