Installing Batteries - Panasonic CZ-RWSU2N Bedienungsanleitung

3. Installing Batteries

1. Remove the cover.
2. Insert two LR03 size batteries.
Put the batteries in with the polarity [+/–]
as shown in the fi gure.
3. Gently insert one end of an
unfolded paper clip (or a similar
object that can fi t) into the Reset
hole and press the Reset button
inside the hole, then put the cover
back on.
Notes
• Change the batteries when the display of the
remote controller gets weak, or if it will not work
unless close to the receiver.
(Alkaline batteries generally last about one year.)
• When changing batteries, always use two fresh batteries of the same make.
• If the remote controller will not be used for a long period of time, remove the batteries.
• Please dispose of batteries appropriately.
• After changing the batteries, follow the procedures on the next page to reset the
current time.
How to Remove Batteries
1. Remove the cover.
2. Press the battery toward the
negative end and lift it out by
its positive end. (See the
fi gure on the right.)
3. Remove the other battery in
the same way.
Note
• Dispose of the used batteries at the designated location in compliance with the
applicable local ordinances.
Warning
• Do not swallow the battery.
• After removing the battery from remote controller, keep it out of the reach of children.
The battery can cause death by suffocation if swallowed.
• When inserting the battery, make sure the polarities (+ and -) are correct.
10
(EN)
Reset hole
Cover