Timer Operation; Using The Timer - Panasonic CZ-RWSU2N Bedienungsanleitung

6. Timer Operation

• When setting the timer, make sure the current time on the remote controller
is accurate.
• The timer's clock can only be set when the display of the remote controller
is ON.
• After setting the timer, put the remote controller for in a place where its
signal will reach the receiver of the indoor unit. (When the time set for the
timer is reached, a signal is sent from the remote controller to start or stop
the unit.)

Using the Timer

1. Press either
while the time is being displayed, if you
press
be set.
The time last set on the timer is displayed.
"--:--" indicates time to change the batteries.
2. Press either
set the timer to the desired time.
Every time you press
10 minute increments. If you press and hold the
button, the time changes quickly.
3. After setting the timer, if you press
time you set changes to a steady display,
indicating settings are complete.
After the timer setting is displayed for three seconds,
the display reverts to the current time.
14
(EN)
/ of the
/ again, a scheduled time can
/ of the
/
or , and
or
, the time changes in
, the
and
3 1, 2