After Using The Appliance; Regular Maintenance - Panasonic EH2513 Bedienungsanleitung

Using your pore cleanser
Using
We recommend you use it when your pores are enlarged such as after
•
taking a bath, etc.
Cleansing two or three times a week is recommended.
•
1. Remove any make-up from your face, leaving your skin bare.
Never use the appliance on skin coated with cleansing lotion or facial
•
soap.
2. Remove the cap and pour tap water into the water tank.
3. Slide the power switch to "1".
The mist nozzle will produce a fi ne spray of water.
•
4. Move the appliance slowly around the tip of
your nose.
Roughly cleanse the entire surface of your
•
nose without focusing on any one spot.
If you apply the nozzle directly on to your
•
skin to improve adhesion, the mist will
automatically stop.
5. Move the appliance over your nose in the
direction of the arrows.
6. Rinse your face, and keep your face suffi ciently moisturized using
moisturizing lotion or any other skin conditioner you normally use.
Around the tip and wings of nose
1. Move the appliance all over your nose for 1 minute.
2. Move it over the wings of your nostrils for 2 minutes.
(Do not repeatedly move it over the wings of your nostrils where the skin is
sensitive.)
When mist is not released
1. Turn the power switch off and remove the cap, then
insert the pointed end of the cleaning tool or a
cotton swab into the mist nozzle a few times.
2. Pour tap water into the water tank.
3. Turn the power switch on and block the mist nozzle for approximately
10 seconds (while checking to see if the water in the tank is bubbling).
4. Drain the water out of the water tank.
4
EH2513_EU.indb 4
If the mist is still not released after repeating the steps above, take the
•
appliance to your dealer.
Water droplets may sometimes be found on the appliance. This is normal.
•
This is the water that has remained after inspection and is sanitary.
Cleaning your pore cleanser
Cleaning

After using the appliance

The appliance can be washed using just water.
1. Pour water (warm if you like) into a washbowl.
Do not use hot water or detergent.
•
2. Remove the suction cup, soak the suction hole (fi lter) in
the water, and turn the power switch on to wash for
approximately 15 seconds.
3. Remove the appliance from the water. Then, leaving
the appliance switched on for approximately
30 seconds to allow water to drain from the body, shake
the water off.
4. Empty the water tank and allow it to dry by leaving the
cap off.
5. Wipe the body of the appliance and the suction cup
with tissues or cotton swabs, taking particular care to
thoroughly wipe the insides of the suction cup.

Regular maintenance

Suction hole (fi lter)
Turn the power switch off, soak the suction hole (fi lter) in
the water (warm if you like), and then remove any
accumulated dirt using the cleaning brush provided.
Do not use the needle side of the brush for cleaning.
•
Do not use hot water (70 °C or higher) or detergent.
•
Mist nozzle
Turn the power switch off and remove any dirt using
the supplied cleaning tool.
2007/11/06 EH2513_EU.indb 15:02:11 5
5
2007/11/06 15:02:12