CHÂTEAU MIRROR
WARNINGS
The product is only safe if installed by qualified personnel and used as intended and
in accordance with the maintenance regulations. The replacement of any components
must be carried out by qualified personnel in compliance with current standards and
using materials with the same electrical, thermal and mechanical characteristics.
The lighting source contained in this device can only be replaced by the manufacturer
and by qualified personnel (IEC2020 | 3.3.21 - light sources that cannot be replaced by
the user)
The cables of the single-insulation system must never come into contact with metal
parts.
Before installing the device, check its integrity. In case of defects or doubts, contact the
retailer. Any defective elements must be replaced immediately. To prevent the risk of
electrocution or burns, the LED elements must be replaced after turning off the mains
power switch. Before switching it on again, check that all the light bulbs are screwed in
and are of a wattage not exceeding the value indicated on the product label.
Caution: the product is for indoor use. Do not install outdoors.
All packaging (boxes, plastic bags, polystyrene, etc.) must be kept out of the reach of
children as it may be a source of danger
E
(risk of suffocation, abrasions, etc.).
E
N
N
G
The company accepts no liability for installations that do not comply with current
G
standards and for assembly and maintenance that do not comply with these warnings
and instructions.
Leave a copy of these instructions with the person in charge of maintenance.
Château is fitted with a motion sensor. The LED light turns on when the door is opened
and turns on about 15 seconds after it is closed.
Power Factor = 0.77
I = 0.09 a
FOR THE "NO LED" MODEL, FOLLOW THE INSTRUCTIONS UNTIL POINT 6.4 AND IGNORE POINT 5.
20
21