Modster CHARGER 100 Bedienungsanleitung Seite 45

SYSTEM SET
It will be operated with the default value of the essential user settings
when it is connected
screen displays the below information
change the value of parameter on each screen
Press START/
press Dec. or Inc. button. The value will be stored by press START/
ENTER button again
PROGRAM S EL ECT
s YSTEM
Rest T i ne
CHG>DCHG 1 0M
<DEC
SAFETY T
ON 1 20M
<DEC_ INC -OEC
UP
to a DC 11—18V battery at the first time. The
ENTER button to make it blink then change the value by
User set up starting screen.
SET
The battery is on the cyclic process of charge and
discharge can often become warm after charge or
discharge
n
delay to occur after each charge and discharge
process to allow the battery adequate time to cool
down before being subjected
INCY
The value ranges from I to 60 minutes
When you start a charge process, the integra
safety time automatically starts running at the
same time. This is programmed
n
overcharge the battery if it proves to be faulty,
or if the termination
battery full. The value for the safety time should
be generous enough to allow a full charge of the
battery.
Safe time
When charging
the capacity by current, then divide the result
in sequence
period. The program can insert a time
circuit
Calculation
NiMH or NiCD batteries, divide
and the user can
to the next process.
to prevent
cannot detect the