Modster CHARGER 100 Bedienungsanleitung Seite 37

LITHIUM BATTERY
Charger 100 charger comes with the built in switch mode power
supplies. You can connect the AC power cord directly to the main AC
socket (100-240V AC), or you can connect an external power supply
(12-18v) or 12v car battery to the DC input socket
PLEASE NOTE: The charger MUST be powered before you connect a
battery to the charger, failure to have the charger powered
connecting a battery can cause charger failure if any connections are
incorrect. The charger must to be powered
an incorrect connection and warn you of this before you can go too far
and cause damage.
MUST disconnect the battery immediately! Never remove power from
the charger first.
Before connecting
last time that you have set the charging
settings are incorrect,
burst into flames or explode. Check that your wiring is correct polarity
from the charger to your battery, double check to be safe
To avoid short circuiting
leads to the charger first, and only then to the battery. Always unplug
the battery from the charge leads when disconnecting
remove the leads from the charger when a battery is connected to
them
BALANCE SOCKET:
The balance wire attached
charger with the black wire aligned with the negative
care to maintain correct polarity! (See the wiring diagram on the next
page.)
CONNECTING
To connect a lithium battery with a balance plug please follow these
procedures.
CONNECTION
If you get the warning "Reverse
any battery it is absolutely
the battery may be damaged,
a battery you must a ways connect the charge
to the battery must be connected
THE BATTERY
DIAGRAM
in order for it to recognize
Polarity" you
essential to check one
parameters correctly.
and could even
the pack, never
marking. Take
up before
If the
to the