Modster CHARGER 100 Bedienungsanleitung Seite 35

•l WARNING
O Charging
During charge process, a specific quantity of electrical
into the battery. The charge quantity is calculated by multiplying charge
current by charge time. The maximum
varies depending
found in the information by the battery manufacturer. Only batteries
that are expressly
be charged at rates higher than the standard charge current.
Connect the battery to the terminal of the charger: red is positive and
black is negative.
and connector, the charger can not detect resistance of the battery
pack. The essential
the charge lead should be of adequate
high quality connectors which are normally goldplated should be fitted
to both ends.
Always refer to the manual by the battery manufacturer pertaining
to charging methods.
charging current and charging time. lithium batteries,
should be charged strictly according to the manufacturer's instruction.
Close attention should be paid to the connection of lithium batteries.
Do not attempt to disassemble
Please get highlighted
parallel and in series. In the parallel connection, the battery's capacity
is calculated by multiplying
of cells, bearing in mind that total voltage stays the same. If the voltage
is imbalanced, it may cause a fire or explosion. Lithium batteries are
recommended
AND SAFTEY
on the battery type or its performance,
stated to be capable of quickcharge
Due to the difference
requirement
Operate according
that lithium battery packs can be wired in
single the battery's capacity by the number
to charge in series.
NOTE
permissible
between resistance
for the charger to work properly is that
conductor
to their recommended
the battery pack arbitrarily.
energy is fed
charge current
and can be
are allowed to
of cable
cross-section, and
in particular,