Modster CHARGER 100 Bedienungsanleitung Seite 29

•l WARNING
These warnings
follow the instructions for maximum safety; otherwise the charger and
the battery can be damaged
the chapter before you begin
Never leave the charger unsupervised
power supply. If any malfunction
PROCESS IMMEDIATELY and refer to the operation manual.
O Keepthe chargerwellawayfromdust,damp,rain, heat,direct
sunshine and vibration.
The allowable DC input voltage is 11-18V DC
The allowable AC input voltage is 100-240V AC
This charger and the battery should be put on a heat-resistant,
non-flammable
a car seat, carpet or similar surface. Keep all flammable
materials away from the operating area
O Makesure youknowthe specifications of the batteryto be
charged or discharged to ensure it meets the requirements of this
charger. If the program is set up incorrectly, the battery and
charger may be damaged.
overcharging. This warranty is not valid for any damage or
subsequent
observe the procedures
O Toavoidshortcircuitingbetweenthe chargelead,alwaysconnect
the charge cable to the charger first, then connect the battery.
Reverse the sequence
O
Never attempt to charge or discharge the following types of
batteries:
A battery pack which consists of different types of cells (including
different manufacturers)
A battery that is already fully charged or just slightly discharged
Non-rechargeable
A faulty or damaged battery
A battery fitted with an integral charge circuit or a protection circuit.
AND SAFTEY
and safety notes are particularly
or at worst it can cause a fire. Also read
Never drop it.
and non-conductive
damage arising as a result of a misuse or failure to
outlined
when disconnecting
batteries
NOTE
when it is connected
is found, TERMINATE
surface. Never place them on
Fire or explosion
in this manual
(pose an explosion
important. Please
THE
volatile
can occur due to
hazard)
to its