Connecting The Receiver To An Electronic Speed Controller - Carson Reflex Wheel Pro 4 Betriebsanleitung

CONNECTING THE RECEIVER TO AN ELECTRONIC SPEED CONTROLLER

Battery eliminator is installed in the receiver circuitry. The receiver
gets supplied with current through the drive battery that runs the
engine.
Only use electronic speed controllers with BEC system!
Electronic speed controller
(not included)
Receiver
Do not connect a separate power supply
to the receiver!
GB // 20
Connector motor
Connector battery
Power switch On-/Off
Steering servo
Channel 1
(not included)
ATTENTION
Make sure that male and female
connectors have the correct polarity!