Transmitter Handling - Carson Reflex Wheel Pro 4 Betriebsanleitung

TRANSMITTER HANDLING

A. THROTTLE TRIGGER
Forward/
Speed up
Neutral
C. TRIM/SERVO REVERSE
ST-REV
ST-TRIM+
ST-D/R+
TH-TRIM+
TH-D/R+
3. Kanal
Throttle Trim (TH-TRIM):
Trim the throttle servo slightly when the trigger is at the neutral position.
Steering Trim (ST-TRIM):
If the front wheels do not align straight, use the steering trim to adjust.
ST dual rate / TH dual rate (TH-D/R-ST-D/R):
Dual rate proportionally increases or decreases the servo travel relative to the travel of the steering wheel / accelerator lever over the
complete servo travel.
Press the potentiometers D/R ST or D/R TH to change the dual rate setting of the steering or throttle.
REV switch / servo reverse:
Use the REV switches (TH REV + ST REV) to reverse the direction of rotation of the servos.
'CH3' channel 3:
Here you can operate a servo using a button.
'CH3' Programming function:
You have the option of using this channel as a 'switch' or as a button.
Switch function: press and hold the CH3 button for several seconds.
(1x short beep - button function) (2x long beep - switch function)
Brake/
Speed down
Left
TH-REV
ST-TRIM-
ST-D/R-
TH-TRIM-
TH-D/R-
B. STEERING WHEEL
Neutral
1. Push the trigger
forward to slow down
or brake.
2. Pull the trigger back-
ward to accelerate.
Right
27 // GB