Fail Safe Function Setting; Binding The Receiver - Carson Reflex Wheel Pro 4 Betriebsanleitung

SETTING FAIL SAFE
Works only on channel 2!
1. Switch off the receiver
2. Connect the „binding cable" to the receiver using the „ FAIL
SAFE PINs" . connection, see figure.
3. Switch on the receiver (LED flashes)
4. Bring the remote control into the desired „ FAIL-SAVE"
position and switch on.
5. Hold the position until the LED is lit permanently.
6. Switch off the receiver and remove the „binding cable".
GB // 28

BINDING THE RECEIVER

1. Switch off the receiver
2. Connect the "binding
cable"to the receiver using
the „PAIR PINs" connec-
tion, see figure.
3. Switch on the receiver (LED
flashes)
4. Switch on the remote
control (LED flashes
permanently - binding
completed).
5. Switch off the receiver
and remove the „binding
cable" again.