Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Operating and safety instructions
These
installation
and
contain important information concerning the
safe and efficient use of the AQA drink Pro 20
water dispenser. Despite all safety precautions,
there remain residual hazards with every product,
especially if it is not handled properly. Every
technical device requires regular maintenance and
servicing (Chapter 6) to work properly. Compliance
with all safety and handling instructions provided
is a fundamental requirement for safe operation. In
addition, the local accident prevention regulations
and general safety regulations valid at the location
of the device apply.
Danger due to electricity!
Before performing maintenance work on this device,
it must be disconnected from the mains supply.
It must be possible to disconnect the electric current
either by pulling out the power cable or by means of
a biploar mains switch at the socket.
If the power cable is damaged, it must be replaced by
the manufacturer or a qualified technician.
Do not use extension cables or multiple adapters.
Check to ensure that the voltage indicated on the
type plate matches that in the installation location.
The device must be secured with an earthing switch.
Earthing the device is a legal requirement.
The electrical connections must comply with local
standards.
This water dispenser was designed and constructed
in accordance with the Low Voltage Directive
2006/95/EC and the protection regulations of the
EC directive 2004/108 EMC.
Caution!
In the event of any use other than for the intended
purpose, e.g. the use of the water dispenser for the
treatment of water which is not of drinking water
quality, drinking this water may constitute a danger
to health:
-
microbiological risk as a result of exposure to
pathogenic germs
-
risk due to high concentrations of heavy metals
or organic contaminants
19
operation
instructions
Caution!
Before maintenance work is carried out on the drink-
ing water supply, disconnect the device from the
water supply. Rinse the water pipe before the device
is reconnected.
Comply
with
all
country-specific
regulations (e.g. DIN 1988, EN 1717), general hygiene
conditions and technical data relating to the
protection of drinking water.
The materials of the water dispenser which are
in direct contact with the water comply with
the regulations and and common food insdustry
standards. The device was manufactured according
to the provisions of the Italian Ministerial Decree D.M.
174 of 06/04/2004 and D.M. 25 of 07/02/2012.
Avoid storing the device for unnecessarily long
periods in order to minimise the risk of microbial
contamination.
The lines of the coolant circuit must not be damaged
because they are filled with R134a gas, which is
highly inflammable. Check the lines on a regular
basis.
Set up the unit in a clean, dry and well-ventilated
room. The AQA drink Pro 20 water dispenser is
designed for room temperatures of between 5 °C and
32 °C – climate class N.
Do not set up the unit near sources of heat or open
flames.
Chemicals, solvents and vapours must not come into
contact with the device.
The installation location must be protected from frost
and direct sunlight.
4.1 Warranty and Disclaimer
The AQA drink Pro 20 water dispenser has a 2-year
warranty. The specified information and recom-
mendations, as well as the local drinking water and
waste disposal regulations valid for the application
in question, must be complied with. All information
and instructions in these installation and operating
instructions take account of applicable standards
and regulations, the state of the art, as well as our
many years of knowledge and experience. Illustra-
tions in this manual are intended to provide a basic
understanding and may vary from the actual design
of the device. No claims may be derived from this.
BWT can accept no liability for damage or conse-
quential damage due to:
•
non-compliance with the information given in
these installation and operating instructions;
installation
Werbung
