Maintenance; Removing The Door; Moving The Top Heating Element; Replacing The Oven Lamp - Whirlpool AKZ 6240 IX Bedienungs- Und Wartungsanleitung

AFTER USE
WARNING

REMOVING THE DOOR

1. Open the door fully.
2. Lift the catches and push them forwards as far
as they will go (Fig. 1).
3. Close the door as far as it will go (A), lift it up
(B) and turn it (C) until it is released (D) (Fig. 2).
To refit the door:
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door.

MOVING THE TOP HEATING ELEMENT

(SOME MODELS ONLY)
1. Remove the side accessory holder grills (Fig. 3).
2. Pull the heating element out a little (Fig. 4) and
lower it (Fig. 5).
3. To reposition the heating element, lift it up,
pulling it slightly towards you, making sure it
comes to rest on the lateral support.
Fig. 3

MAINTENANCE

- Use protective gloves.
- Ensure the oven is cold before carrying out the following operations.
- Disconnect the appliance from the power supply.
Fig. 1
Fig. 2
Fig. 4
Fig. 5

REPLACING THE OVEN LAMP

To replace the rear lamp:
1. Disconnect the oven from the power supply.
2. Unscrew the lamp cover (Fig. 6), replace the
lamp (see note for lamp type) and screw the
lamp cover back on.
3. Reconnect the oven to the power supply.
NOTE:
- Only use 25-40W/230V type E-14, T300°C
incandescent lamps, or 20-40W/230 V type G9,
T300°C halogen lamps.
- The lamp used in the appliance is specifically
designed for electrical appliances and is not
suitable for household room illumination
(Commission Regulation (EC) No 244/2009).
- Lamps are available from our After-sales Service.
IMPORTANT:
- If using halogen lamps, do not handle with bare
hands as fingerprints can damage them.
- Do not use the oven until the lamp cover has
been repositioned.
Fig. 6
EN 25