Battery Charging - Mpm Mod-72 Bedienungsanleitung

ASSEMBLY OF THE VACUUM CLEANER
CAUTION! Do not operate the vacuum cleaner when it is not assembled!
CAUTION! Make sure that you do not damage the delicate connectors powering the
electric brush while assembling the pipe and accessories.
1. Slide the battery (7) into the motor module (3). A characteristic click will be heard. Then as-
semble the aluminium pipe (14) with the motor module (3). Finally, assemble the electric brush
(18) to the aluminium pipe (14).
2. In order to disassemble the vacuum cleaner act similarly to the 1st point.
ASSEMBLY AND PARKING OF THE VACUUM CLEANER SWITCH ON
THE STATION
The MOD-72 vacuum cleaner is equipped with a free-standing station (20) allowing for
storing the vacuum cleaner and its accessories. Wall mounting is not required.
1. Mount two tubes (22) to the base of the station (21), then attach the holder for storing the vac-
uum cleaner and its accessories (23).
2. Choose an appropriate storage place to accommodate the station with the vacuum cleaner.

BATTERY CHARGING

CAUTION! Charge the battery before using the vacuum cleaner for the first time. The
time required to charge the battery is approximately 4 hours. A fully charged battery is
able to provide up to 45 minutes of vacuuming at low suction power.
CAUTION! Only charge the battery with the supplied charger. While the battery is
charging, the vacuum cleaner cannot be started.
1. Connect the charger (24) to the mains socket and the charger cord to the socket in the holder
(1) The battery charge status (5d) will start flashing on the LED display (5), while the charging in-
dicator (5a) will be lit. The lights on the battery (7) will flash to indicate the battery charge level.
EN
37