Joie Signature i-Level Pro Bedienungsanleitung Seite 9

Installation Concerns
see images -
1 4
Canopy
see images -
5 6
Handle Adjustment
see images -
7 8
1. The handle of the infant carrier can be adjusted to 2 positions.
Position for car, hand or stroller transportation
position -2.
7
2. To adjust the handle, squeeze handle buttons on both sides
and then rotate the handle until it clicks into a locked position.
Head Support Height Adjustment
see images -
9 12
!
Shoulder harness straps must be nearest to the child's shoulders
but not above the shoulder line.
!
If the shoulder harness straps are not at proper height, the child
might be ejected from the enhanced child restraint in the event of a
crash.
Press the head support adjustment lever
down the head support until it snaps into a locked position. The head
support positions are shown as
7
-1. Baby chair
7
10
11 , meanwhile pull up or push
.
12
Backrest Adjustment
see images
There are 3 backrest recline angles.
Please press backrest adjustment button
backrest angles.
Securing Child
in the Enhanced Child Restraint
see images
Note
7 1. Infant insert is for child's side protection. We recommend using
the infant insert when the baby is under 60cm or until they outgrow
the insert.
-1,
8
2. Make sure the infant insert already has the foam wedge in it
8 -1
before using the insert.
1. Loosen the harness straps by pressing the Harness Adjustment
9 ,
Button and pulling on the straps.
2. Press button and remove the Buckle Tongues from the buckle
3. Place your child into the infant carrier module and insert buckle
tongues into the buckle.
4. Pull on the adjustment strap to tighten the harness
-
13 14
to raise up or lower the
13
14
-
15 19
Remove the infant insert when your
child's shoulders no longer fit comfortably.
15
&
17 18
16
19
8