Residual Risks; Preparation; Control Elements - Parkside Paexs 20-Li B2 Originalbetriebsanleitung

GB MT
• Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the workpiece by your hand or
against the body leaves it unstable and
may lead to loss of control.
• Only use the power tool for dry
sanding. Do not scrape moist
materials. Penetration of water into
the electrical device increases the risk
of electric shock.
• Avoid overheating the sanded
object and the sander itself. Pos-
sible fire hazard.
• The workpiece gets hot during
sanding. Do not touch the ma-
chined area, allow it to cool
down. There is a risk of burns. Do not
use coolants or the like.
• Always empty the dust contain-
er before work breaks. Sanding
dust in the dust sack, micro filter, pa-
per sack (or in the filter sack or extrac-
tion system filter) can self-ignite under
unfavourable conditions such as flying
sparks caused by sanding metals. Par-
ticular hazards are caused if the sand-
ing dust is mixed with paint, polyureth-
ane residues or other chemical sub-
stances, or if the sanded object is hot
after long working periods.
• Wait until the power tool has
stopped before placing it
down.
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.

Residual risks

There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
30
may occur in connection with the type and
design of this power tool:
• Eye damage if no suitable eye protec-
tion is worn.
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Abrasions.
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.

Control elements

Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• On/Off switch (3)
• Switching on: Press forward, the on/
off switch locks in place
• Switching off: Push backward
• Rotary wheel (4)
Set the rotational speed in 6 incre-
ments.