Werbung
OPERATION
•
When the heater is powered on, the buzzer sounds, the WLAN light
flashes and the appliance is in a standby state. When the WLAN
connection has been successfully established, the WLAN light stays on.
•
When you press the ON key, the digital display shows the ambient
temperature with the Celsius symbol.
•
The default temperature is 25 °C. When the ambient temperature is
higher than or equal to the target temperature and the device does not
heat. When the ambient temperature is less tahn 1 °C below the target
temperature , the heating lights turn on and device heats up.
Operation via the control panel on the unit
Temperature setting
Press the UP and DOWN keys to adjust the temperature between 5–50 °C.
Both digits flash 5 times after no operation to confirm.
Timer setting
Press the SET button once and the timing icon is on with the "h". Set the timing
shutdown by pressing the UP and DOWN keys to set a time to 0-24 hours.
After setting the display flashes 5 times to enter the contdown shutdown.
When the setting is complete, swtich to display the ambient temperature. The
timing icon is on, buth the "h" indicator is off.
Heating level setting
Press the SET button for the second time to set the heating level. The digital
screen will display "H1" or "H2".
"H1" indicates the low heating level. "H2" indicates the high heating level.
Press the UP and DOWN buttons and the corresponding icon on the left will
light up.
After the setting is completed, the two digits will flash for 5 seconds and
confirm after no operation, the digital screen will return to display the ambient
temperature (half sun icon and full sun icon).
Child lock
To activate the child lock, press and hold the UP botton. To deactivate the child
lock, press and hold the DOWN button.
WLAN connection control
Press and hold the SET button to forcibly disconnect the connected APP, and
the WIFI light flashes again.
EN
25
Werbung
