Beurer FC 90 Gebrauchsanweisung Seite 14

• Ensure that the mains cable and mains adapter do not come into contact with water, steam or
other liquids.
• Never reach for a device that has been submerged in water. Pull the mains adapter out of the
mains socket immediately.
Repairs
WARNING
• Do not open the device.
• Only specialist personnel may perform repairs on electrical devices. Improper repairs may subject
users to considerable danger. For repairs, please contact Customer Services or an authorised
retailer.
Risk of fire
WARNING
There is a risk of fire if the device is used improperly or these instructions for use are ignored.
• Never use the device underneath a cover, such as a blanket or pillow.
• Never use the device near highly flammable substances.
• Make sure that the vents are not covered.
• Never store the device while it is still switched on. Always switch the device o before storing it.
• Do not expose the device to high temperatures.
5. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
Treatment head
1
ON/OFF button
3
Positive ions button
5
Cool button
7
6. INITIAL USE
WARNING
Keep packaging material away from children! There is a choking hazard.
• Remove the device from the packaging and check that the device and all accessories are included
and not damaged.
• Plug the mains cable into the bottom of the device.
• Ensure that the mains cable does not pose a trip hazard.
• Plug the mains adapter into the socket.
7. USAGE
WARNING
Before starting the treatment, carry out a skin sensitivity test to check whether your skin is sensitive to
the cleansing milk and the Advanced Hydro Lift Cream. To do this, proceed as follows:
• Clean a patch of skin in the crook of your arm thoroughly, apply a little of the cleansing milk and
Advanced Hydro Lift Cream to this cleaned patch of skin and allow the product to soak in and dry.
• If the skin shows no reactions within the next 48 hours, you can use the tested products without
hesitation.
LCD display
2
Negative ions button
4
Heat button
6
14