EMC Information
Essential performance of FlexScan L362T is to display images and operate functions normally.
CAUTION
The FlexScan L362T requires special precautions regarding EMC and need to be installed, put into
service and used according to the following information.
Do not use any cables other than the cables that provided or specified by us.
Using other cables may cause the increase of emission or decrease of immunity.
Do not put any portable and mobile RF communications equipment close to the FlexScan L362T.
Doing so may affect the FlexScan L362T.
The FlexScan L362T should not be used adjacent to or stacked with other equipment. If adjacent
or stacked use is necessary, the equipment or system should be observed to verify normal
operation in the configuration in which it will be used.
Guidance and manufacturer's declaration - electromagnetic emissions
The FlexScan L362T is intended for use in the electromagnetic environment specified below.
The customer or the user of the FlexScan L362T should assure that it is used in such an environment.
Emission test
RF emissions
EN55011
RF emissions
EN55011
Harmonic emissions
EN61000-3-2
Voltage fluctuations /
flicker emissions
EN61000-3-3
Compliance
Electromagnetic environment - guidance
Group 1
The FlexScan L362T uses RF energy only for its internal function.
Therefore, its RF emission are very low and are not likely to cause
any interference in nearby electronic equipment.
Class B
The FlexScan L362T is suitable for use in all establishments,
including domestic establishments and those directly connected
to the public low-voltage power supply network that supplies
Not applicable
buildings used for domestic purposes.
Complies