Warranty Period - Anova Rlt14Pto Aufbauanleitung Und Benutzerhandbuch

6. TROUBLESHOOTING
Warning
Do not perform any maintenance actions with the engine running. Turn off the machine and
unplug the equipment.
Problem Possible causes
Adjusting the switch
No split blade
release lever with two
movement
hands
Hydraulic
Oil loss, dirty floor.
equipment
Note:If you have any questions or problems persist after performing the above operations, contact your
dealer or service center.
7. WARRANTY
If your product suffers from a manufacturing defect during the established warranty period,
please contact or go to your point of sale directly with the necessary documentation.
Your purchase invoice should be kept as proof of the purchase date. Your tool must be
returned to your dealer in acceptable, clean condition, in its original molded case, if applicable
to the unit, accompanied by your applicable proof of purchase.

7.1. Warranty period

The legal warranty period of the product begins on the original date of purchase by the first
initial buyer and its duration will be that established by the Royal Decree-Law on the protection
of consumers and users against situations of social and economic vulnerability of the year.
corresponding to the time of purchase of the product.
Some countries do not allow limitations on how long an implied warranty lasts or do not allow
the exclusion or limitation of consequential or incidental damages, in which case the above
limitation and exclusion may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state or country to country.
7.2. Exclusions
This warranty does not cover product damage or performance problems caused by:
- Natural wear and tear.
- Misuse, neglect, careless operation or lack of maintenance.
- Defects caused by incorrect use, damage caused due to manipulations carried out by
personnel not authorized by Anova or use of non-original spare parts.
- Defects of normal wear parts, such as bearings, brushes, cables, plugs or accessories
such as drills, bits, saw blades, etc.
Possible
- Check the oil level.
- A defective control valve should be replaced only
by a service center.
- Tighten the screws
- Replace hoses
16
EN