Anova RLT14PTO Aufbauanleitung Und Benutzerhandbuch Seite 90

Caution
Pay the necessary attention to the hydraulic hoses. Carefully and slowly insert the screws into
the hole, grab the switching handle and tighten the nuts on the screws (fig. 4).
Attention
Never guide the cylinder quickly upwards or use force, any operating error on the part of the
user is excluded from the warranty.
With the cylinder raised
Pay attention to the direction of speed
For transportation reasons
Place a wooden block with a height of approx. 15 – 20 cm on the floor board. Pull the shift
handles and drop the dividing wedge onto the wood block. Now grab the shift lever and lock
the rearward movement. Now turn off the engine.
- Lock the limit switch if you are alone.
- Screw both nuts on the installed pin to release the cylinder board from the frame (image
4).
- Now connect the motor again.
- The cylinder now lowers to the splitting wedge if the operating lever is not pulled.
- When it has fallen, pull the switching lever and turn off the product.
Start the engine and pay attention to the direction of rotation. If the switch does not respond
when the operating levers are pulled, the polarity must be changed immediately.
Work with two hands
Wear proper work gloves when splitting wood.
- The wood is moved to the table using a lifting device (image 6).
- The splitting process is started by moving both handles downward.
- Blade movement is stopped by releasing one or both levers.
- The blade returns to the up position when both switching handles are pushed up.
Split wood length
The product is suitable for splitting one meter blocks and wood. The maximum cut can be
limited. The effective upward cutting limitation is approx. 3 – 5 cm above the wood.
11
EN