Oil Change - Anova Rlt14Pto Aufbauanleitung Und Benutzerhandbuch

- All protective and safety equipment must be reinstalled immediately after completion
of repair and maintenance.
5.1.1. We recommend the following:
Splitting wedge/blade
The blade is subject to rapid wear, so you will need to replace it if necessary. This will increase
cutting performance and protect the splitter.
Only use a single wedge, you cannot use a cross wedge. Grease before leaving.
- Two-handed protective equipment for your safety.
- The operation of the combined clamping and switching device must be smooth.
Sometimes it can be lubricated with a few drops of oil.
- The machine has moving parts, take special care.
- Keep the splitting blade guide clean (no dirt, splinters, bark, etc.)
- Check that the hydraulic connections and screws are tight and not worn. Tighten the
screws if necessary.

5.1.2. Oil change

(fig. 11)
- Check the oil level (the product must be level). The oil tank is located in the divider
column.
- Unscrew the oil drain screw (fig. 11).
- Collect the drained oil (different amount in each model)
o Dispose of drained oil in an environmentally friendly manner.
o Screw the oil drain screw back on. Caution! No dirt should reach the oil tank.
o Add hydraulic oil to the oil fill level. Consult your nearest distributor if you have
any questions.
13
EN